Club Car Turf 1 Service Manual page 57

ACCELERATOR AND BRAKE PEDAL GROUP
Figure 5-22 Brake Pedal Height Adjustment
3. Adjust park brake ratchet/pawl gap and pawl engagement.
3.1. Inspect the park brake pawl and ratchet for excessive wear, grooves, cracks, or chips. If either the
pawl or ratchet is damaged, both must be replaced.
3.2. Adjust retaining nut (7) on spring support rod until there is a 0.060 inch (1.5 mm) gap between the
pawl and the tips of the ratchet teeth. Use a feeler gauge to verify the gap (Figure 5-24,
Page 5-17). The gap should be consistent through range of pawl movement. If the gap is not con-
sistent, loosen the four bolts (6) securing the accelerator pivot rod supports and adjust the supports.
If the gap becomes smaller as the park brake pedal is pressed, move the pivot rod supports slightly
rearward until the gap is consistent. If the gap becomes larger as the park brake pedal is pressed,
move the pivot rod supports slightly forward until gap is consistent.
B
A
0.060 inch
(1.5 mm)
3.3. With the park brake unlocked, measure and note the distance from the top of the accelerator pedal
to the floorboard, then lock the park brake (Figure 5-25, Page 5-18).
22
31
BOTTOM VIEW
Figure 5-24 Park Brake Ratchet/Pawl Gap Adjustment
2012 Turf/Carryall Vehicle Maintenance and Service Manual
Pedal Group Adjustment – Electric Vehicles
Correct pedal
position is
6 inches (15.2 cm)
from floormat to
back of
brake pedal.
Figure 5-23 Brake Pedal Height Measurement
CUTAWAY SIDE VIEW
6
5
7
Page 5-17