6
WHEEL BRAKE ASSEMBLIES
Front Brake Cable Installation, Continued:
REAR BRAKE CABLES
See General Warning, Section 1, Page 1-1. See also Warning, on Page 6-1.
REAR BRAKE CABLE REMOVAL
1. Chock wheels to keep vehicle from unintentionally moving.
2. Release park brake if latched and loosen equalizer retaining nuts (1) on equalizer rod (2) to slightly
loosen brake cables (3) (Figure 6-38, Page 6-23).
3. Rotate brake cables upward and pull ends through holes in top of equalizer.
4. Disconnect brake cables at rear wheels.
4.1. Remove bow-tie pins (1), clevis pins (2), and E-clips (3) (Figure 6-39, Page 6-23).
4.2. Remove cable (4) from cable support bracket (5).
4.3. Note location of hangers (for installation of cables). Pull cables out of vehicle.
Page 6-22
2012 Turf/Carryall Vehicle Maintenance and Service Manual
Figure 6-37 Front Brake Cable Routing
2
7
3
Rear Brake Cables