Trailer Hitch - Heavy Duty (Optional On Some Models); Trailer Hitch Removal - Heavy Duty; Trailer Hitch Installation - Heavy Duty; Tailskirt - Club Car Turf 1 Service Manual

BODY AND TRIM
TRAILER HITCH – HEAVY DUTY (OPTIONAL ON SOME MODELS)
See General Warning, Section 1, Page 1-1.
TRAILER HITCH REMOVAL – HEAVY DUTY
1. Remove the tailskirt. See Tailskirt Removal on page 4-15.
2. Where the hitch (7) is mounted to frame, remove two nuts (12), lock washers (11), flat washers (10), and
bolts (9) (Figure 4-5, Page 4-13).
3. Where the hitch (7) is mounted to hitch brace (8), remove the nut (12), lock washer (11), flat washer (10),
and bolt (9).
4. Remove hitch (7) from vehicle.
TRAILER HITCH INSTALLATION – HEAVY DUTY
1. Install trailer hitch (7) in the reverse order of removal (Figure 4-5, Page 4-13). Tighten hardware to 15
ft-lb (20.3 N·m).

TAILSKIRT

See General Warning, Section 1, Page 1-1.

TAILSKIRT REMOVAL

1. Remove two thread-forming screws (5) and flat washers (13) from tailskirt (4) and lift tailskirt from vehicle
frame (Figure 4-5, Page 4-13 or Figure 4-6, Page 4-14).

TAILSKIRT INSTALLATION

1. Insert upper edge of tailskirt (4) under, and in front of, back edge of rear body (Figure 4-5, Page 4-13 or
Figure 4-6, Page 4-14).
2. Align holes in tailskirt (4) with holes in vehicle frame. Position tailskirt flush against frame.
3. Install two thread-forming screws (5) and flat washers (13) in tailskirt and tighten to 80 in-lb (9.0 N·m).

FLOOR MAT

See General Warning, Section 1, Page 1-1.

FRONT FLOOR MAT REMOVAL

1. Remove the brake and accelerator pedals. See Section 5 – Accelerator and Brake Pedal Group.
2. Remove horn switch if so equipped.
3. Remove the top edge of the floor mat from the overlapping flange under the dash.
4. Lift the mat from the vehicle.
2012 Turf/Carryall Vehicle Maintenance and Service Manual
4
Tailskirt
Page 4-15