Club Car Turf 1 Service Manual page 64

6
WHEEL BRAKE ASSEMBLIES
Brake Assembly Cleaning (Self-Adjusting Brakes), Continued:
ý
WARNING
• Apply grease carefully when performing the following steps. Do not allow any grease to get
on the friction surfaces of the brake shoe pads. Failure to heed this warning could cause
diminished brake performance, possibly resulting in property damage or severe personal
injury.
4. Use a small brush to carefully apply a light coat of white lithium NLGI #2 grease (Dow Corning
or equivalent) on each of the six raised bosses on brake backing plate (Figure 6-8, Page 6-4). See pre-
ceding WARNING.
5. Use a small brush to carefully apply a light coat of white lithium NLGI #2 grease (Dow Corning BR2-Plus
or equivalent) to each end of both brake shoes and into the slots in the brake shoe mounting block as
shown (Figure 6-9, Page 6-4). See preceding WARNING.
BOSSES
Figure 6-8 Lubricate Raised Bosses
6. Use a small brush to carefully apply a light coat of white lithium NLGI #2 grease (Dow Corning BR2-Plus
or equivalent) to the brake adjuster assembly, adjuster wheel shoe slots, and the shaft of the adjuster
wheel as shown (Figure 6-10, Page 6-4). See preceding WARNING.
7. Install the adjuster wheel and two washers into the adjuster assembly (Figure 6-10, Page 6-4).
Figure 6-10 Lubricate Adjuster
Page 6-4 2012 Turf/Carryall Vehicle Maintenance and Service Manual
Brake Assembly Cleaning (Self-Adjusting Brakes)
BOSSES
Figure 6-9 Lubricate Shoes
®
BR2-Plus