Club Car Turf 1 Service Manual page 71

WHEEL BRAKE ASSEMBLIES
1. Position one shoe in the slots in the mounting block anchor piston and brake actuator (Figure 6-23,
Page 6-11). See following WARNING.
ý
WARNING
• When installing brake shoes, the shoes must be oriented with tips stamped J10 inserted into
the mounting block anchor piston slots rather than into the brake actuator slots (Figure 6-23,
Page 6-11). Incorrectly installed brake shoes will be too tight and make adjustment of the
brake impossible.
Figure 6-23 Position Shoes
2. Install shoe retainer clip (1), using pliers to compress clip while turning clip retainer pin (2) into position
(Figure 6-24, Page 6-11).
3. Attach the springs (with hooks pointing outwards) onto the shoe already installed. Then hold the other
shoe next to it, correctly oriented, and attach the springs to it (Figure 6-25, Page 6-12). See following
NOTE.
NOTE: With brake shoe tips marked J10 oriented to the mounting block, the stamping will be
visible on one shoe only. The other J10 stamping will be facing the backing plate and
will not be visible.
4. While maintaining spring attachment on both shoes, position the tips of the second shoe into mounting
slots and then push shoe into place. Hold shoe in position and install the retaining clip and pin
(Figure 6-25, Page 6-12).
5. After the shoes are installed, move them together up and down and side to side to make sure that they
will easily slide approximately 1/4 to 3/8 inch (6.3 to 9.5 mm) without binding. Make sure the shoes are
positioned vertically so the tips of the shoes are positioned flush with the top surface of the shoe mount-
ing blocks as shown (Figure 6-26, Page 6-12). See following CAUTION.
Brake Shoe Installation (Manually-Adjusted Brakes)
J10 STAMPING
ON SHOE
2012 Turf/Carryall Vehicle Maintenance and Service Manual
Figure 6-24 Retainer Clip
6
1
2
Page 6-11