Club Car Turf 1 Service Manual page 90

7
STEERING AND FRONT SUSPENSION
STEP 1
BEARING
PRESS TOOL
(CCI P/N 1014264)
STEP 2
Figure 7-5 Steering Shaft – Bottom End
3. Position the steering column assembly in the vehicle while inserting the steering column shaft into the
upper universal joint (1). The flat portion of the steering shaft spline (19) must be aligned with the bolt hole
in the universal joint (1) before sliding the spline into the universal joint. While holding the steering col-
umn in place, attach it to the frame using bolts (8), washers (7), and nuts (9) (Figure 7-3, Page 7-3).
Thread the nuts onto the bolts but do not tighten them.
4. Install wide washer (35), washer (11) and screw (10). Tighten to 20 ft-lb (27 N·m) (Figure 7-3, Page 7-3).
5. Install the bolt (2) and lock washer (3) on the upper universal joint and finger-tighten.
6. Tighten the two nuts (9) and bolts (8) to 18 ft-lb (24.4 N·m) (Figure 7-3, Page 7-3).
7. Tighten the bolt (2) on the upper universal joint to 15 ft-lb (20 N·m) (Figure 7-3, Page 7-3).
8. Check the other two bolts of the universal joint (1) to ensure that they are properly tightened to 15 ft-lb
(20 N·m) (Figure 7-3, Page 7-3).
9. Reinstall dash pocket and related hardware.
10. Reinstall center dash panel in reverse order of disassembly. Make sure the key switch terminals do not
touch the frame and the center dash panel is properly seated and snapped into place.
11. Install front body and bumper. See Front Body Installation, Section 4, Page 4-4.
12. Install the steering wheel. See Steering Wheel Installation on page 7-2.
Page 7-6 2012 Turf/Carryall Vehicle Maintenance and Service Manual
19
13
18
14
20
15
18
16
17
Wedge seating
into the inner
races of bearing.
STEP 3
RETAINING TOOL
(CCI P/N 1014259)
STEP 1
BEARING
PRESS TOOL
(CCI P/N 1014264)
17
STEP 2
races of bearing.
Figure 7-6 Steering Shaft – Top End
Steering Column
COLUMN
22
16
20
19
2 to 2-1/8 inches
(5.1-5.4 cm)
18
16
Wedge seating
into the inner
STEP 3