Club Car Turf 1 Service Manual page 67

WHEEL BRAKE ASSEMBLIES
4. While maintaining spring attachment on both shoes, position tips of leading shoe in the mounting slots
and then push shoe into place. Hold shoe in position and install retaining clip (Figure 6-15, Page 6-7).
TRAILING
LEADING SHOE
Figure 6-15 Install Leading Shoe
5. After the shoes are installed, move them together up and down and side to side to make sure that they
will easily slide approximately 1/4 to 3/8 inch (6.3 to 9.5 mm) without binding. Make sure the shoes are
positioned vertically so that the tips of the shoes are positioned flush at the top with the top surfaces of
the wedge shapes on the shoe mounting blocks as shown (Figure 6-16, Page 6-7).
6. Place a flat blade screwdriver under the adjusting arm and raise arm off of the adjusting wheel. While
holding the arm up, turn the wheel upward until it stops (Figure 6-17, Page 6-7). Remove the screw-
driver. See following CAUTION.
ý
CAUTION
• Clean any residual oil from the exposed end of the axle shaft and from the oil seal area prior to
installing the axle shaft.
Figure 6-16 Slide Shoes
SHOE
A
B
TIPS
2012 Turf/Carryall Vehicle Maintenance and Service Manual
Brake Shoe Installation (Self-Adjusting Brakes)
ADJUSTING
ARM
Figure 6-17 Turn Adjusting Wheel
(Self-Adjusting Brakes)
6
ADJUSTING
WHEEL
Page 6-7