Brake Assembly Cleaning (Self-Adjusting Brakes) - Club Car Turf 1 Service Manual

WHEEL BRAKE ASSEMBLIES
Figure 6-4 Rotate Clip Retainer
7. Grasp both brake shoes and pull them, with the springs, out of brake assembly (Figure 6-5, Page 6-3).
8. Self-adjusting brake vehicles only: Remove the adjuster wheel (1) with two washers (2 and 3) from
the backing plate (Figure 6-6, Page 6-3).
Figure 6-6 Remove Adjuster Wheel

BRAKE ASSEMBLY CLEANING (SELF-ADJUSTING BRAKES)

See General Warning, Section 1, Page 1-1. See also Warning, on Page 6-1.
1. Carefully clean the brake backing plate and all of its mechanical components.
2. Remove the rubber boot from backing plate and wipe with a clean damp cloth.
3. Lubricate the slide (1) and slide plate (2) with dry moly lubricant (CC P/N 1012151) on both sides of the
backing plate. After lubricating, work the slide back and forth to ensure it slides smoothly and easily
(Figure 6-7, Page 6-3). Reinstall rubber boot onto backing plate. See following WARNING.
2
1
1
2
3
2012 Turf/Carryall Vehicle Maintenance and Service Manual
Brake Assembly Cleaning (Self-Adjusting Brakes)
Figure 6-5 Remove Shoes
1
2
Figure 6-7 Lubricate Slide
6
Page 6-3