Brake Pedal Installation - Club Car Turf 1 Service Manual

5
ACCELERATOR AND BRAKE PEDAL GROUP

BRAKE PEDAL INSTALLATION

1. From the top side of the floorboard, insert the brake pedal assembly (10) (Figure 5-1, Page 5-2 or
Figure 5-2, Page 5-3) through the opening in the floor as shown (Figure 5-3, Page 5-4) and install the
brake pedal stop bumper (24) (Figure 5-1, Page 5-2 or Figure 5-2, Page 5-3) on the brake pedal
assembly, but do not tighten the jam nut (25) at this time.
2. Secure the equalizer rod(s) (14 and 36) to the brake pedal assembly (10) with clevis pin(s) (16) and bow-
tie pin(s) (15) as shown (Figure 5-1, Page 5-2 or Figure 5-2, Page 5-3). See following NOTE.
NOTE: On two-wheel brake vehicles, the equalizer rod is secured to the left (driver-side)
channel on the brake pedal weldment.
For Turf 2 and Carryall 2 vehicles with four-wheel brakes and Carryall 2 Plus vehicles,
there are two equalizer rods. The long rod (21-1/4 inches (54 cm)) is secured to the
left (driver-side) channel, and the short rod (9-1/4 inches (23.5 cm)) is secured to the
right (passenger-side) channel on the brake pedal weldment.
On Turf 6 and Carryall 6 vehicles, there are two equalizer rods. The long rod (42-1/4
inches (107.3 cm)) is secured to the left (driver-side) channel on the brake pedal
weldment, and the short rod (9-1/4 inches (23.5 cm)) is secured to the right (passen-
ger-side) channel on the brake pedal.
3. Position and attach brake pedal assembly, mounting blocks (26), and washers (27) to vehicle frame as
shown. Tighten the bolts (28) and nuts to 95 in-lb (10.7 N·m) (Figure 5-1, Page 5-2 or Figure 5-2,
Page 5-3).
4. Adjust the pedal group. Refer to the appropriate adjustment procedure:
• For gasoline vehicles, see Pedal Group Adjustment – Gasoline Vehicles on page 5-11.
• For electric vehicles, see Pedal Group Adjustment – Electric Vehicles on page 5-16.
Figure 5-3 Brake Pedal Weldment Through Floor
Page 5-4 2012 Turf/Carryall Vehicle Maintenance and Service Manual
Brake Pedal and Park Brake
Figure 5-4 Park Brake Assembly