Accelerator Pedal - Gasoline Vehicles; Accelerator Pedal Removal - Gasoline Vehicles - Club Car Turf 1 Service Manual

5
ACCELERATOR AND BRAKE PEDAL GROUP
Hook one end of spring (20)
on park brake weldment.
20
Figure 5-5 Torsion Spring Installation
ACCELERATOR PEDAL – GASOLINE VEHICLES
See General Warning, Section 1, Page 1-1.
ACCELERATOR PEDAL REMOVAL – GASOLINE VEHICLES
1. Disconnect battery and spark plug wire(s). See Disconnecting The Battery – Gasoline Vehicles on
page 1-3.
2. Place chocks under the rear wheels and lift the front end of the vehicle with a chain hoist or floor jack.
Place jack stands under the front cross tube of the vehicle frame and lower the vehicle onto the jack
stands. See following WARNING.
ý
WARNING
• Lift only one end of the vehicle at a time. Use a suitable lifting device (chain hoist or hydraulic
floor jack) with 1000 lb. (454 kg) minimum lifting capacity. Do not use lifting device to hold
vehicle in raised position. Use approved jack stands of proper weight capacity to support the
vehicle and chock the wheels that remain on the floor. When not performing a test or service
procedure that requires movement of the wheels, lock the brakes.
3. Disconnect the accelerator rod assembly (17, 25, and 24) (Figure 5-6, Page 5-7) at the front and rear
ball studs and remove it from the vehicle.
4. Use a 9/16-inch socket and 9/16-inch wrench to remove the nut (7), two washers (5), and bolt (4) secur-
ing the accelerator pedal (1) to the pivot rod (6).
5. Remove the nut (10) and ball stud (8) from the accelerator pivot rod assembly (6).
6. Slide the spring retainer (11) off of the accelerator pivot rod.
7. Inspect the pivot support bearing (9) for wear and replace if necessary.
8. Use a marker to mark the position of the park brake ratchet (23) on the accelerator pivot rod (6). See fol-
lowing NOTE.
NOTE: Failure to mark position of the ratchet could cause it to be reinstalled improperly,
resulting in improper adjustment and possible failure of the park brake.
Page 5-6 2012 Turf/Carryall Vehicle Maintenance and Service Manual
SHAFT
Lift other end of spring (20) up and
over brake weldment by prying down
on shaft with small screwdriver.
Accelerator Pedal – Gasoline Vehicles