Removing The Rfi Bracket - HP 6000 330s Owner's Manual

Models 330S and 660S
HP Series 6000
Removing the RFI Bracket from Slot 3
4-32 CD-ROM Drive
The mass storage system chassis is shipped with a radio
frequency interference (RFI) bracket in slot 3 (unless slot
3 contains a factory-installed optional SCSI device). The
RFI bracket ensures the compliance of your mass storage
system with RFI emission requirements whenever there is
no device in slot 3. If a CD-ROM drive has not yet been
installed into slot
3,
you must first remove the RFI bracket
as follows (see Figure 4-8):
1. Remove the T25 screw from the front of the mass
storage system chassis and the RFI bracket.
2. Use a flat-bladed screwdriver to pry the RFI bracket
away from the mass storage system chassis.
3. Slide the RFI bracket on the chassis rails toward the
center of the mass storage system chassis and lift the
RFI bracket out of the chassis.