Table of Contents
Advertisement
Models 330S and 660S
Connecting the Cables
2-18
Hard Disk Drive
HP Series 6000
Connect cables to the hard disk drive as follows (see
Figure 2-9 and Figure 2-10):
1. Lift the hard disk drive from the conductive sheet, then
gently push the BEND/flex cable connectors toward the
center of the chassis, and lower the mounting tabs into
the mounting slots in the chassis rails.
2. Before securing the hard disk drive in place, connect the
hard disk status indicator cable to the corresponding
BEND /flex status indicator connector for the proper slot
number.
3. Connect the BEND/flex address connector to the address
connector on the hard disk drive.
4. Connect the BEND/flex SCSI connector to the SCSI
connector on the hard disk drive.
5. Connect one end of the dc power cable to the dc power
connector on the hard disk drive.
6. Connect the other end of the dc power cable to any of
the unused dc power connectors on the power supply
(see Figure 2-11).
7. Secure the dc power cable with the cable tie next to the
power supply (see Figure 2-4).
Advertisement
Table of Contents
