Table of Contents
Advertisement
HP Series 6000
Models 330S and 660S
Wrist Ground Strap
The wrist ground strap is used to ensure that the DAT
drive, the conductive sheet, the mass storage system
chassis, and your hand are all at the same electrical
potential.
TORX Tools
The TORX tools are used to drive TORX screws.
Hex Standoff
The hex standoff is use when a hard disk drive is installed
(or moved) into slot 2.
BEND/flex Cable Adapter
The BEND/flex cable adapter is a 50-pin cable with
two connectors that adapt the Small Computer System
Interface (SCSI) connectors on the DAT drive to the SCSI
connector on the BEND/flex cable. The BEND/flex cable
SCSI connector enables DAT drives to communicate with
the host computer (initiator) over an industry-standard
single-ended SCSI bus.
Address Jumpers
The address jumpers are used to connect address pin
sets together. This sets the SCSI address of your DAT
drive. The DAT drive is shipped with four address jumpers
installed across one pin (not set).
DAT Cassette
See "Product Media" in this chapter.
Cleaning Cassette
The cleaning cassette is used to clean the tape head within
the DAT drive periodically.
Digital Audio Tape Drive 5·19
Advertisement
Table of Contents
