Removing The Rfi Bracket; Installing The Scsi Devices - HP 6000 SERIES Hardware Installation Manual

Hardware Installation Manual HP Series 6000
Removing the RFI Bracket
The mass storage system chassis is shipped with a radio frequency interference
(RFI) bracket in empty front slots. The RFI bracket ensures the compliance of
your mass storage system with RFI emission requirements whenever there is no
device in the front slots.
If
you are installing a device in either of the front slots, you must first remove
the RFI bracket as follows (see Figure 1-5):
1. Remove the T25 screw from the front of the chassis.
2. Use a flat-bladed screwdriver to pry the RFI bracket toward the rear of the
chassis.
3. Slide the RFI bracket toward the center of the chassis until the mounting
tabs stop against the ends of the mounting slots.
4. Lift the RFI bracket out of the chassis.
5. Discard the RFI bracket.
Installing the SCSI Devices
Refer to the appropriate chapter in this manual for device installation. When
the device is installed, return here and complete the procedures in this chapter
for removing the front panel bezels, connecting the dc power cable, and
reinstalling the top cover and front panel.
1·14 Mass Storage System