Virtual Power Button; Manual Power Button; Removing The Hp Aio Sb600C Server Blade - HP StorageWorks All-in-One SB600c Storage Blade Solution User Manual

IMPORTANT:
When the server blade is in standby mode, auxiliary power is still being provided. To remove all power
from the server blade, remove the server blade from the enclosure.
To power down the HP AiO SB600c, first power down the HP AiO SB600c Server Blade. Depending on
the Onboard Administrator configuration, use one of the following methods to power down the server
blade, the virtual power button or the manual power button located on the server blade.

Virtual Power Button

Two ways are available to access the virtual power button, either through the Onboard Administrator
interface or through iLO 2.
• Select the virtual power button through the Onboard Administrator interface. (Preferred method)
• Use a virtual power button selection through iLO 2.
This method initiates a controlled remote shutdown of applications and the OS before the server blade
enters standby mode. You must be logged into the server to complete this task.

Manual Power Button

The manual Power On/Standby button is located on the server blade.
• Press and release the Power On/Standby button.
This method initiates a controlled shutdown of applications and the OS before the server blade enters
standby mode. You must be logged into the server to complete this task
• Press and hold the Power On/Standby button for more than 4 seconds to force the server
blade to shut down.
CAUTION:
This method should only be used when no other shut down methods are available. Applications and
files could be permanently corrupted from this method.
This method forces the server blade to enter standby mode without properly exiting applications and
the OS. It provides an emergency shutdown method in the event of a hung application.
After initiating a virtual power down command, be sure that the server blade goes into standby mode
by observing that the system power LED is amber.

Removing the HP AiO SB600c Server Blade

To remove the component:
1.
Identify the proper server blade.
2. Power down the server blade.
See Powering down the HP All-in-One SB600c Storage Blade Solution
information.
3.
Ensure the server is completely off before removing the blade from the chassis.
4. Open the locking clip located on the lower left of the server blade.
20 Operations
on page 19 for more