HP Series 6000
Models 330S and 660S
Do not operate your DAT drive if it has been exposed to
extreme temperatures, such as being left in an automobile
overnight in cold weather. Your DAT drive must stabilize
at room temperature for two hours before operation.
Operating your DAT drive when it is very cold or very hot
could cause damage to your DAT drive. Refer to the end of
this chapter and also to chapter 1 for limits on temperature
and humidity for your mass storage system.
The following paragraphs describe how to operate your
DAT drive.
Switching on Power
To switch on power to your DAT drive, push in the
(LlNE- )
switch on the mass storage system front panel. To switch
off power to your DAT drive, push in the
(LiNE-)
switch
then release it until it is fully extended out. (See Figure 1-2
in chapter 1 for the location of the
(LlNE- )
switch.)
Digital Audio Tape Drive 5-7