Setting The Address Jumpers - HP 6000 330s Owner's Manual

HP Series 6000 Models 330S and 660S
9. Place the bag containing the DAT drive on the
conductive sheet. Cut open the bag, remove the DAT
drive, and place the DAT drive on the conductive sheet.
10. Set the address jumpers on the DAT drive to the
desired address (refer to "Setting the Address
Jumpers").
11. Disconnect the ac power cord from the mass storage
system rear panel.
Ensure that the (LINEN) switch on the mass storage
system front panel is in the 0 (out) position, and that
the power cord is disconnected from the mass storage
system rear panel. Electrical shock may result if the
power cord is connected and the (LINEN) switch is in the 1
(in) position while the top cover is off.
Setting the Address Jumpers
The address switches on the back of your mass storage
system are for hard disk drives only.
The address pin sets on the rear panel of the DAT drive
enable you to select a unique SCSI address for the drive
(see Figure 5-5). The numbers 0, 1, and 2 above the pin
sets correspond to SCSI address bits 0, 1, and 2. When a
jumper is placed on a pin set, the corresponding address bit
is set to
1.
When no jumper is in place on a pin set, the
corresponding address bit is set to O. Your DAT drive is
shipped from the factory with four jumpers installed on one
of the address pin sets (not set), so the SCSI address is set
to O.
Digital Audio Tape Drive 5·21