Table of Contents
Advertisement
Models 330S and 660S
HP Series 6000
Installing a CD-ROM Drive into the Mounting Bracket
4-34 CD-ROM Drive
Perform the following steps only if you are adding a second
CD-ROM drive beneath an existing CD-ROM drive in slot
3:
1. Remove the dc dual power cable from the DC SUPPLY
connector on the rear of the CD-ROM drive.
2. Disconnect the BEND jflex SCSI adapter connector from
the CD-ROM drive SCSI connector by pressing both
cable ejectors outwards until the cable is removed.
3. Remove the T25 screw from the chassis front panel,
and remove the CD-ROM drive from slot 3 with the
CD-ROM bracket attached.
4. Place both of the CD-ROM drives on the conductive
sheet.
5. Remove the T10 bracket screws from the new CD-ROM
drive and bracket you received in the new upgrade kit.
6. Remove the new CD-ROM drive from the mounting
bracket.
7. Install the new CD-ROM drive into the lower level of the
mounting bracket you removed from slot 3.
8. Secure the CD-ROM drive in the mounting bracket with
the T10 bracket screws (see Figure 4-9).
Advertisement
Table of Contents
