Models 330S and 660S
Connecting the Cables
HP Series 6000
Connect the cables to the DAT drive as follows (see
Figure 5-12 and Figure 5-13):
1. Connect one end of the power cable to any of the
unused dc power connectors on the power supply (see
Figure 5-13), route the power cable to the DAT drive,
and connect the other end of the power cable to the dc
power connector on the DAT drive.
2. Connect the BEND/flex cable adapter to the BEND/flex
cable.
3. Connect the other end of the BEND/flex cable adapter to
the SCSI connector on the DAT drive (see Figure 5-12).
The cable adapter may have to be folded slightly as
shown to fit properly.
5-34 Digital Audio Tape Drive