Table of Contents
Advertisement
Models 330S and 660S
HP Series 6000
Disconnecting the Cables
Disconnect the cables from the DAT drive as follows:
1.
Disconnect the dc power cable from the de power
connector on the DAT drive.
2. Disconnect the dc power cable from the slot 1 power
connector on the power supply (see Figure 5-13), then
cut the power cable tie wrap.
3. Disconnect the BEND/flex SCSI connector from the
DAT drive SCSI connector by pressing both cable
ejectors outwards until the cable is removed.
4. Disconnect the cable adapter from the BEND/flex SCSI
connector by pressing both cable ejectors outwards until
the cable is removed.
5·40
Digital Audio Tape Drive
Advertisement
Table of Contents
