Connecting Cables To A Cd-Rom Drive - HP 6000 330s Owner's Manual

Models 330S and 660S HP Series 6000
Connecting Cables to a CD-ROM Drive
4-40 CD-ROM Drive
Connect the cables to your CD-ROM drive as follows:
1. Connect the BEND/flex cable adapter to the. BEND/flex
cable.
2. If you are installing only one CD-ROM drive, connect
only one of the split ends of the dc dual power cable
to the DC SUPPLY connector on the rear panel of the
CD-ROM drive (see Figure 4-12), and connect the long
end of the dc dual power cable to any of the unused dc
power connectors on the power supply (see Figure 4-13).
If you are installing two CD-ROM drives, connect both
of the split ends of the dc dual power cable to the DC
SUPPLY connectors on the rear panels of the CD-ROM
drives (see Figure 4-12), and connect the long end (with
the 14-pin connector) of the dc dual power cable to
the slot 3 power connector on the power supply (see
Figure 4-13).
3. If you are installing only one CD-ROM drive, attach
only the upper SCSI connector of the BEND/flex
cable adapter to the SCSI connector on the rear of the
CD-ROM drive (see Figure 4-12).
If you are installing two CD-ROM drives, attach the
upper SCSI connector of the BEND/flex cable adapter
to the upper CD-ROM drive, and attach the lower SCSI
connector of the BEND/flex cable adapter to the lower
CD-ROM drive.