HP 6000 330s Owner's Manual page 119

HP Series 6000 Models 330S and 660S
Installing the Rewritable Optical Controller PCA into Slot 1
1. Install the PCA mounting bracket into the mass storage
system chassis with the bracket-to-chassis screw as
shown in Figure 3-10.
2. Lift the rewritable optical controller PCA from the
conductive sheet and slide it into the PCA guides in slot
1 (see Figure 3-10 and Figure 3-11). Make sure that
the two holes in the controller PCA toward the front
of the mass storage system
align
with the holes in the
mounting bracket beneath the controller PCA.
3. Attach the two bracket-to-PCA screws through
the controller PCA into the mounting bracket (see
Figure 3-11). Do not over-tighten these screws.
Rewritable Optical Disk Drive 3·35