Table of Contents
Advertisement
Models 330S and 660S
HP Series 6000
Reinstalling the Front Panel and Top Cover
Install the front panel and top cover as follows (see
Figure 2-3):
1. Slide the top cover down over the mass storage system
chassis so that the rear of the top cover extends one-half
inch beyond the rear of the mass storage system chassis,
then slide the top cover fOlWard into place.
2. Install and tighten the T15 top cover screws.
3. Insert the front panel mounting tabs into the slots in
the top cover and swing the front panel down until the
[UNE-)
switch comes through the opening in the front
panel.
4. Push the bottom edge of the front panel into the front of
the chassis until the front panel locking tabs engage.
5. Remove the wrist strap from the mass storage system
chassis and your wrist.
6. Reconnect the SCSI cable and the power cord to the
mass storage system rear panel.
Setting the Address Switches
2-26
Hard Disk Drive
The system disk should always be set to SCSI address
number 6. To set the SCSI address switches for the hard
disk drive(s) to the desired address, refer to chapter 1.
Advertisement
Table of Contents
