Hp Series 6000 - HP 6000 330s Owner's Manual

Models 330S and 660S
HP
Series 6000
Make sure your DAT drive is set to a unique SCSI address
relative to the other devices on the SCSI bus. The mass
storage system will not function properly if two devices
in the mass storage system have the same SCSI address.
Refer to chapter 1 for information on checking address
switch settings for the hard disk drives.
To set your DAT drive to a different address before
installing the DAT drive into the mass storage system,
install jumpers across address pin sets to set address bits
to 1, or leave jumpers off address pin sets to set address
bits to O. Table 5-4 shows the SCSI address for the
corresponding bit settings.
To set the address to a different setting after your DAT
drive has been installed into your mass storage system
chassis, perform the following steps:
1. Set the mass storage system
(LlNE- )
switch to the 0 (out)
position.
2. Disconnect the power cord from the mass storage system
rear panel.
3. Remove the front panel and top cover (refer to
"Removing the Front Panel and Top Cover" in this
chapter).
4. Install jumpers across address pin sets to set address bits
to 1, or leave jumpers off addresss pin sets to set address
bits
to
O.
5·22 Digital Audio Tape Drive