Removing The Trim Bracket And Filler Panel; Figure 1-3 Removing The Trim Bracket And Filler Panel - HP C7745NB - SureStore DLT Tape Autoloader 1/9 Manual

Hp surestore tape autoloader model 1/9 upgrade and parts replacement guide

Hide thumbs Also See for C7745NB - SureStore DLT Tape Autoloader 1/9:

Table of Contents

Figure 1-3

Overview and Preparation for Upgrade

Removing a Rackmounted Autoloader (if necessary)

Removing the Trim Bracket and Filler Panel

It is not necessary to remove the trim bracket and filler panel in order to

upgrade your autoloader, however, it is necessary if you are returning the

autoloader.

To remove the trim bracket and filler panel, do the following:

1. Remove the trim bracket from the right side of the autoloader by

lifting up gently on the bracket until it separates from the autoloader.

Guide pins keep the bracket in place (see Figure 1-3).

2. Remove the filler panel or trim bracket from the left side by gently

lifting up on the panel until it separates from the autoloader. Guide

pins keep the panel in place (see Figure 1-3).

Removing the Trim Bracket and Filler Panel

1-6

Chapter 1

Table of Contents

Do you have a question about the C7745NB - SureStore DLT Tape Autoloader 1/9 and is the answer not in the manual?