HP 6000 330s Owner's Manual page 225

HP Series 6000
Removing the
DAT
Drive
Models 3305 and 6605
Remove the DAT drive from your mass storage system
chassis as follows:
1. Remove the T25 screw from the front of the mass
storage system chassis (see Figure 5-10).
2. Use a flat-bladed screw driver to pry the front of the
DAT drive away from the mass storage system chassis.
3. Slide the DAT drive on the chassis rails toward the
center of the mass storage system chassis until the
mounting tabs stop against the ends of the mounting
slots.
4. Push the BEND/flex cable connectors toward the center
of the chassis and lift the DAT drive out of the mass
storage system chassis and onto the conductive sheet.
If you are relocating your DAT drive within your mass
storage system, proceed now to the "Installing the DAT
Drive" in this chapter.
5. If the DAT drive is not being relocated into another slot,
place the DAT drive into a conductive bag.
6. Install the front panel and top cover on the mass storage
system chassis (refer to "Installing the Front Panel and
Top Cover" in this chapter).
7. Remove the wrist strap from the mass storage system
chassis and your wrist.
Digital Audio Tape Drive 5-41