Table of Contents
Advertisement
Models 330S and 660S
HP Series 6000
Removing the Front Panel and Top Cover
Remove the front panel and top cover as follows (see
Figure 3-6):
1. Slide the front of the mass storage system chassis
beyond the edge of the table top until the front panel
locking tabs are exposed. The tabs are located on the
underside of the chassis.
2. Press up on the front panel locking tabs until the front
panel releases from the mass storage system chassis.
3. Pull the bottom of the front panel fOlWard, rotate the
front panel up, and lift the front panel mounting tabs
out of slots in the front edge of the top cover.
4. Remove the two T15 top cover screws.
5. Slide the rear of the top cover one-half inch beyond the
rear of the mass storage system chassis, then lift the
front of the top cover up and off of the mass storage
system chassis.
Removing the Front Panel Bezels
Remove the front panel bezels as follows (see Figure 3-7):
1. Position your thumbs in front of the bezel on the
right-hand and left-hand edges of the bezel.
2. Gently push the bezel out with your thumbs.
3-28 Rewritable Optical Disk Drive
Advertisement
Table of Contents
