Removing The Hard Disk Drive - HP 6000 330s Owner's Manual

HP Series 6000 Models 330S and 660S
Removing the Hard Disk Drive
1. Remove the T25 screw from the front of the mass
storage system chassis.
2. If you are removing a hard disk drive from slot 1 or slot
3, remove the T25 screw from the hole in the front
of the mass storage system chassis (see Figure 2-6 or
Figure 2-8).
If you are removing a hard disk drive from slot 2,
remove the T25 screw from the hole in the rear of the
mass storage system chassis (see Figure 2-7).
3. Use a flat-bladed screw driver to pry the front of the
hard disk drive toward the center of the mass storage
system.
4. Slide the hard disk drive toward the center of the mass
storage system chassis until the mounting tabs stop
against the ends of the mounting slots.
5. Gently push the BEND /tlex cable connectors toward the
center of the chassis with one hand and lift the hard disk
drive out of the mass storage system chassis and onto
the conductive sheet.
If you are relocating your hard disk drive within your mass
storage system, proceed now to "Installing a Hard Disk
Drive" in this chapter.
6. If the hard disk drive is not being relocated into another
slot, place the hard disk drive into a conductive bag.
7. Install the front panel and top cover on the mass storage
system chassis (refer to "Installing the Front Panel and
Top Cover" in this chapter).
8. Remove the wrist strap from the mass storage system
chassis and from your wrist.
Hard Disk Drive 2·31