HP 6000 330s Owner's Manual page 173

HP Series 6000 Models 330S and 660S
Installing a CD-ROM Drive into Slot 3
Install a CD-ROM drive into the mass storage system
chassis as follows:
1. Hold the BEND/flex cable out of the way with one hand,
and lift the CD-ROM drive or drives in the mounting
bracket from the conductive sheet and lower the bracket
mounting tabs into the mounting slots in the chassis
rails (see Figure 4-10 and Figure 4-11).
2. Push down on the mounting bracket and slide it on the
chassis rails toward the front of the mass storage system
chassis until the mounting tabs lock into the mounting
slots and the mounting bracket stops against the front of
the chassis.
3. Tighten the T25 screw through the hole in the mass
storage system chassis and into the securing tab (see
Figure 4-11).
CD-ROM Drive 4-37