Cd-Rom Drive Scsi-Id Switch Settings - HP 6000 330s Owner's Manual

Models 330S and 660S
4-24 CD-ROM Drive
HP Series 6000
3. Remove the front panel and top cover (refer
to
"Removing the Front Panel and Top Cover
u
in this
chapter).
4. Verify that the PRTY and ARBT switches are set to 1,
and the TEST switch is set
to
O.
5. Set the SCSI switches 1, 2, and 3
to
0 or 1 for the
desired address (refer to Table 4-2 and Figure 4-5).
6. Install the front panel and top cover.
7. Connect the power cord
to
the mass storage system rear
panel.
8. Set the mass storage system
[UNE-)
switch
to
the 1 (in)
position.
Table 4-2.
CD-ROM Drive SCSI-ID Switch Settings
SCSI·ID SCSI·ID SCSI·ID
SCSI 1 2
4
Address Switch 1 Switch 2 Switch 3
0
0 0
0
1 1
0
0
2 0 1
0
3 1 1 0
4
0 0 1
5
1 0
1
6 0 1 1
7
1 1 1