HP 6000 330s Owner's Manual page 158

Models 330S and 660S
4·22 CD·ROM Drive
HP
Series 6000
8. Slide the foam pad beneath the loose end of the
conductive sheet, while making sure the mass storage
system chassis maintains contact with the conductive
sheet.
9. Place the anti-static bag containing the CD-ROM drive
on the conductive sheet. Open the bag, remove the
CD-ROM drive, and place it on the conductive sheet.
10. Set the SCSI-ID, PRTY, ARBT, and TEST switches
on the rear panel of the CD-ROM drive (refer to the
following paragraphs).
11. Disconnect the ac power cord from the mass storage
system rear panel.
Ensure that the
(LINEN)
switch on the mass storage
system front panel is in the 0 (out) position, and that
the power cord is disconnected from the mass storage
system rear panel. Electrical shock may result if the
power cord is connected and the
(LINEN)
switch is in the 1
(in) position while the top cover is off.