Table of Contents
Advertisement
Models 330S and 660S
HP Series 6000
This section provides instructions on how to place your
mass storage system in operation. These instructions
include unpacking instructions, a check of equipment
supplied, and how to connect the mass storage system to
a power source and the Small Computer System Interface
(SCSI) bus.
Unpacking
The mass storage system is shipped in a reusable
shipping container. (See Figure 1-1.) Remove the
mass storage system from this container and inspect
it for any mechanical damage that may have occurred
during shipment. If any damage is observed, you should
immediately notify your dealer or Hewlett-Packard Sales
and Support Office.
Handling
Although the mass storage system has been designed
Static Control
1-8
Mass Storage System
to withstand a certain shock level, it is still a delicate
device. The following precautions should be observed when
handling or transporting the mass storage system. Failure
to observe these handling precautions could result in loss of
data or damage to the product.
Avoid sharp shocks to the mass storage system.
Always repackage the mass storage system in approved
packaging when transporting the product from one area
to another. Use the original packaging material or a
similar substitute.
A static charge of 39,000 volts can be generated on a
carpeted floor. This exceeds the limits of this product and
can cause unsuccessful operation.
Advertisement
Table of Contents
