Installing The Sata And Optical Drive Bays - DFI ST101-CR User Manual

Chapter 3

Installing the SATA and Optical Drive Bays

3. The drive bay bracket will resemble the one shown below.
1. Position the SATA drive at the bottom side of the drive bay bracket.
Top of drive bay bracket Bottom of drive bay bracket
(for optical drive) (for SATA drive)
SATA data connector
SATA power connector
Rear view of the SATA drive
2. To secure SATA to the drive bay bracket, you must fasten screws from the top side of the drive
bay bracket.
While holding the SATA drive in place, turn the drive bay bracket to the top side then adjust the
drive so that the mounting holes on the drive match the mounting holes on the bracket. Now
secure the drive by fastening 4 screws.
Mounting screw
12
Chapter 3 Installing Devices www.dfi.com