DFI ST101-CR User Manual page 13

3. The 2 screws are used to secure the drive bay cover. Remove these screws and the drive bay
cover. Put them in a safe place for later use.
4. After removing the drive bay cover, on the top side of the bracket, position the optical drive as
shown below.
Rear view of the optical drive
Chapter 3 Installing Devices
Chapter 3
Drive bay cover
SATA connector
13
5. Secure the optical drive by fastening screws on each side of the drive bay bracket.
SATA
Optical drive
SATA
6. The figure below shows the cables for SATA drive, the SATA power connector of the power
supply unit, and the locations of the SATA connectors on the system board.
SATA data cable
Optical drive
SATA connector
SATA power cable
For SATA drive
www.dfi.com