Front Panel Connectors; Peripheral Power - DFI ST101-CR User Manual

Front Panel Connectors

HDD-LED - HDD LED
This LED will light when the hard drive is being accessed.
RESET SW - Reset Switch
This switch allows you to reboot without having to power off the system.
PWR-BTN - Power Switch
This switch is used to power on or off the system.
PWR-LED - Power/Standby LED
When the system's power is on, this LED will light. When the system is in the S1 (POS - Power
On Suspend) state, it will blink every second. When the system is in the S3 (STR - Suspend To
RAM) state, it will blink every 4 seconds.
Pin Pin Assignment
3 HDD Power
HDD-LED
5 Signal
7 Ground
RESET SW
9 RST Signal
11 N.C.
Chapter 5 Ports and Connectors
Chapter 5
1 2
PWR-LED
HDD-LED
RESET-SW PWR-BTN
11 12
Pin Pin Assignment
2 LED Power
PWR-LED 4 LED Power
6 Signal
PWR-BTN
8 Ground
10 Signal

Peripheral Power

The peripheral power connector supplies power to the SATA drive and IDE hard disk drive.
Connect one end of the provided power cable to the peripheral power connector and the other
ends to your storage devices.
30
Peripheral Power
1
+12V
Ground
Ground
+5V
4
Connect to the peripheral
power connector
Connect to
storage devices
www.dfi.com