Table of Contents
Advertisement
Wake-On-USB Keyboard/Mouse
The Wake-On-USB Keyboard/Mouse function allows you to use a USB keyboard or USB mouse
to wake up a system from the S3 (STR - Suspend To RAM) state. To use this function:
•
Jumper Setting
JP7 must be set to "2-3 On: +5V_standby". Refer to "USB Power Select" in this chapter for
more information.
Important:
If you are using the Wake-On-USB Keyboard/Mouse function for 2 USB ports, the
+5V_standby power source of your power supply must support ≥1.5A. For 3 or more
USB ports, the +5V_standby power source of your power supply must support ≥2A.
Chapter 5 Ports and Connectors
Chapter 5
Audio
Rear audio
Mic-in/
Center+Subwoofer
Line-in/
Surround
Line-out
10
9
Line2-JD
Line2-L
Key
Front_IO_Sense
Mic2-JD
Line2-R
Presence Signal
Mic2-R
Mic2-L
GND
2
1
Front audio
Rear Audio
The system board is equipped with 3 audio jacks. A jack is a one-hole connecting interface for
inserting a plug.
• Mic-in/Center+Subwoofer Jack (Pink)
This jack is used to connect an external microphone or to connect to the center and sub-
woofer speakers of the audio system.
• Line-in/Surround Jack (Light Blue)
This jack is used to connect any audio devices such as Hi-fi set, CD player, tape player,
AM/FM radio tuner, synthesizer, etc.
• Line-out Jack (Lime)
This jack is used to connect a headphone or external speakers.
Front Audio
The front audio connector allows you to connect to the second line-out and mic-in jacks that
are at the front panel of your system.
BIOS Setting
Configure the onboard audio in the Chipset menu ("South Bridge" submenu) of the BIOS.
Refer to chapter 7 for more information.
Driver Installation
Install the audio driver. Refer to chapter 8 for more information.
25
www.dfi.com
Advertisement
Table of Contents
