DFI ST101-CR User Manual page 42

F71879 Super IO Configuration
This section is used to configure the I/O functions supported by the onboard
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Advanced
F71879 Super IO Configuration
F71879 Super IO Chip Fintek F71879
Restore AC Power Loss
[Power Off]
Watchdog Timer [Disabled]
Super IO Watchdog Timer 10
Serial Port 1 Configuration

Serial Port 2 Configuration

Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Restore AC Power Loss
Off
When power returns after an AC power failure, the system's power is off. You
the Power button to power-on the system.
On
When power returns after an AC power failure, the system will automatically power-on.
Last State
When power returns after an AC power failure, the system will return to the state where
you left off before power failure occurs. If the system's power is off when AC power
failure occurs, it will remain off when power returns. If the system's power is on when AC
power failure occurs, the system will power-on when power returns.
Watchdog Timer
Enable or disable Super I/O watchdog timer.
Chapter 7 BIOS Setup
Chapter 7
Super I/O chip.
Restore AC Power Loss
help.
Select Screen
→ ←:
Select Item
↑↓:
Enter: Select
+/ -: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
ESC: Exit
must press
42
Serial Port 1 Configuration to Serial Port 2 Configuration
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Advanced
Serial Port 1 Configuration
Serial Port [Enabled]
IO=3F8h; IRQ=4;
Device Settings
Change Settings [Auto]
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Enable or Disable Serial
Port (COM)
Select Screen
→ ←:
Select Item
↑↓:
Enter: Select
+/ -: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
ESC: Exit
www.dfi.com