Table of Contents
Advertisement
I/O Connectors
S/PDIF Connector
SPDIF out
Key
Ground
SPDIF in
+5V
1
5
The S/PDIF connector is used to connect an external S/PDIF port. Your S/PDIF port may be
mounted on a card-edge bracket. Install the card-edge bracket to an available slot at the rear
of the system chassis then connect the audio cable to the S/PDIF connector. Make sure pin 1
of the audio cable is aligned with pin 1 of the S/PDIF connector.
Chapter 5 Ports and Connectors
Chapter 5
SATA (Serial ATA) Connectors
Features
• 4 Serial ATA ports
- 2 SATA 2.0 ports with data transfer rate up to 3Gb/s
- 2 SATA 3.0 ports with data transfer rate up to 6Gb/s
• Integrated Advanced Host Controller Interface (AHCI) controller
The Serial ATA connectors are used to connect Serial ATA devices. Connect one end of the Se-
rial ATA cable to a SATA connector and the other end to your Serial ATA device.
BIOS Setting
Configure the Serial ATA drives in the Advanced menu ("IDE Configuration" submenu) of the
BIOS. Refer to chapter 7 for more information.
26
7
1
SATA 0
SATA 3.0 6Gb/s
SATA 1
SATA 4
SATA 2.0 3Gb/s
SATA 5
www.dfi.com
Advertisement
Table of Contents
