Table of Contents
Advertisement
Chapter 4 - Jumper Settings
Clear CMOS
If you encounter the following,
a) CMOS data becomes corrupted.
b) You forgot the supervisor or user password.
you can reconfigure the system with the default values stored in the ROM BIOS.
To load the default values stored in the ROM BIOS, please follow the steps below.
1. Power-off the system and unplug the power cord.
2. Set JP10 pins 2 and 3 to On. Wait for a few seconds and set JP10 back to its default set-
ting, pins 1 and 2 On.
3. Now plug the power cord and power-on the system.
Chapter 4 Jumper Settings
Chapter 4
1 2
3
1-2 On: Normal
(default)
1 2
3
JP10
2-3 On:
Clear CMOS Data
USB Power Select
This jumper is used to select the power of the USB ports. Selecting +5V_standby will allow
you to use a USB device to wake up the system.
Important:
If you are using the Wake-On-USB Keyboard/Mouse function for 2 USB ports, the
+5V_standby power source of your power supply must support ≥1.5A. For 3 or more
USB ports, the +5V_standby power source of your power supply must support ≥2A.
16
3
3
2
2
1
1
USB 0-3
1-2 On: +5V
2-3 On:
(JP6)
(default)
+5V_standby
3
3
2
2
1
1
USB 4-7
(JP7)
2-3 On:
1-2 On: +5V
+5V_standby
(default)
www.dfi.com
Advertisement
Table of Contents
