Chapter 3 - Installing Devices; Removing The Chassis Cover; Removing The Drive Bay - DFI ST101-CR User Manual

Chapter 3 - Installing Devices

Removing the Chassis Cover

1. Make sure the system and all other peripheral devices connected to it has been powered-
off.
2. Disconnect all power cords and cables.
3. The mounting screw at the rear side of the system is used to secure the cover to the chas-
sis. Remove the screw and then put it in a safe place for later use.
Mounting screw
4. Lift the cover by first pulling it backward (1) then lifting it up (2).
(2)
Chapter 3 Installing Devices
Chapter 3
(1)
Side View

Removing the Drive Bay

1. The drive bay bracket is readily accessible when you remove the cover.
Drive Bay Bracket
2. The 4 screws are used to secure the drive bay bracket. Remove these screws and put them
in a safe place for later use.
11
Top View
Side View
www.dfi.com