Table of Contents
Advertisement
H.2 OTHER RELEVANT GPSCARD LOGS
Please refer to the MiLLennium Command Descriptions Manual's logs chapter for a list of GPSCard logs
categorized by function. The binary format descriptions and further details on individual logs may be found in
Appendix D of the same manual, where logs are listed alphabetically.
Table H.2, Page 96 is a table of the receiver's self-test status codes. The status field output consists of 8
hexadecimal numbers which you must then convert to binary, see Page 54. Reading from right to left the first bit
indicates if the antenna signal is good(1) or bad(0). This bit is an OR condition of the antenna. If the signal from
the antenna is good then the status is good(1). If the antenna signal is bad then the status is bad (0). This table is
referenced by the RGEA/B/D log, Page 106 and the RVSA/B log, Page 109.
Bit 18, Table H.3, Page 99 is used for the antenna. This table is referenced by the ETSA/B log, Page 101 and the
RGEA/B/D log, Page 106.
Table H.4, Page 100 is an updated list of the GPSCard range reject codes. This table comes into effect when using
the ETSA/B log, Page 101 or the SATA/B log, Page 110.
NOTE:
To determine the GLONASS PRN for commands that require entry of a PRN, such as ASSIGN, use
this equation:
FREQUENCY * 10000 + SLOT + 37
where the SLOT and FREQUENCY are in the range 1 to 24 inclusive
GPS/GLONASS Receiver User Manual Rev 1
Table H.1, Bits 0 - 1: P1 Flag Range Values
State
Description
00
0 minutes
01
30 minutes
10
45 minutes
11
60 minutes
H NovAtel Format Logs
95
Advertisement
Table of Contents
