Operation; Before Operation; Communications With The Millennium-Glonass Gpscard - Novatel MiLLennium OM-20000040 User Manual

4 Operation

4 OPERATION
4 OPERATION

4.1 BEFORE OPERATION

Before operating the MiLLennium-GLONASS for the first time, ensure that you have followed the installation
instructions of Chapter 3. The following instructions are based on a configuration such as that shown in Figure
4.1. It is assumed that a personal computer is used during the initial operation and testing for greater ease and
versatility.
1
2
4
3
Reference Description
1 Model 504 or 514 Antenna
2 Combined GPS/GLONASS Signal Input
3 Optional External Oscillator
(not available with ProPak II enclosure)
4 Clock
5 GPSCard ProPak II or
PowerPak II enclosure
6 MiLLennium-GLONASS GPSCard
4.2 COMMUNICATIONS WITH THE MILLENNIUM-GLONASS
GPSCARD
Communication with the MiLLennium-GLONASS GPSCard is straightforward, and consists of issuing commands
through the COM1 or COM2 port from an external serial communications device. This could be either a terminal
or an IBM-compatible PC that is directly connected to a MiLLennium-GLONASS GPSCard serial port using a null
modem cable. For specific information about any of the GPSCard commands and logs, please consult the
MiLLennium Command Descriptions Manual.
24
Figure 4.1 Typical Operational Configuration
5
6
7
8
9
Reference Description
7 COM1
8 COM2
9 Power
10 Command Source or
Reference Station
11 Data Logger or
Remote Station
12 External Power Source
GPS/GLONASS Receiver User Manual Rev 1
10
11
12