Table of Contents
Advertisement
E ProPak II Enclosure
E.3.2.1 Mounting Plate (NovAtel part number 70015024)
Reference
Description
1
Thread for flat screw
2
Rectangular nut
3
Grub screw
4
Channel
5
Quick-mount holes to mount assembly
to surface using wood screws
E.3.3 CABLES
Please see the following sections for the technical specifications of all cables and optional accessories. For field
replacement of the LEMO connectors, and to find part numbers of optional accessories, please see Appendix K,
Page 126.
E.3.3.1 I/O Strobe Port Cable
The I/O strobe lines can be accessed by inserting the 8 pin LEMO connector of the I/O strobe port cable (NovAtel
part number 01016330) into the I/O port. The other end of the cable is provided without a connector so that you
can provide an application-specific one; the jacket insulation is cut away slightly from the end but the insulation
on each wire is intact. The Input/Output Strobes section of Table B.1, Page 52 contains descriptions of each of the
I/O strobes, along with their electrical specifications.
For field replacement of the LEMO connector, please consult Appendix K, Page 126 for a list of the manufacturers'
part numbers.
Note that the STATUS line is used to toggle the valid-position LED on the front end-cap between red (power on)
and green (valid position).
Please see Section E.3.3.1.1 for a drawing of the cable.
Two serial data cables are supplied with the ProPak II enclosure to connect the receiver to a PC or modem/radio.
They both look identical but their uses and part numbers differ.
The straight cable (see Section E.3.3.2.1), 10-pin LEMO plug to 9-pin D-connector (DE9P plug), is used to connect
the receiver to a modem or radio transmitter to propagate differential corrections. Its NovAtel part number is
01016383.
The null-modem cable (see Section E.3.3.2.2), 10-pin LEMO plug to 9-pin D-connector (DE9S socket), is used to
connect the receiver to a serial (RS232C) communication port on a terminal or computer. Its NovAtel part number
is 01016329.
64
1
2
3
4
8
Reference
5
6
7
9
Description
6
Holes to mount plate to enclosure using
flat screw
7
Holes to mount assembly to a surface
using self-tapping screws
8
Back of receiver enclosure
9
Front of mounting plate
GPS/GLONASS Receiver User Manual Rev 1
Advertisement
Table of Contents
