Table of Contents
Advertisement
NOTE: The 4-pin LEMO socket connector to 4-pin LEMO plug connector, auto-ranging AC/DC converter and
AC power cord do not come with the ProPak II enclosure but are optional accessories.
The term plug/socket refers to the outside of the connector while the term male/female refers to the pin
type.
E.3.1 POWER SUPPLY CONSIDERATIONS
The ProPak II enclosure incorporates a DC/DC power converter providing filtering, automatic reset circuit
protection and voltage regulation. It accepts a single input voltage between the range +10 to +36 V DC, which can
be supplied either from an automotive DC source or by the optional auto-ranging AC/DC converter (NovAtel part
number GPS-APRO) which operates over a range of 110 - 220 V AC and 50 - 60 Hz. The power input is reverse-
polarity protected. Refer to Table E.1, Page 61, for further information.
WARNING: The MiLLennium-GLONASS GPSCard will suspend operation if voltage supplied falls outside
input range +10 to +36 V DC.
E.3.2 MOUNTING CONSIDERATIONS
A mounting kit is provided with the ProPak II enclosure (see Section E.3.2.1, Page 64) to facilitate mounting it to
a surface. The mounting kit includes the following materials:
•
four self-tapping screws (#10-16 x
•
two wood screws (#10 x
•
four flat screws (M3 x 8, 90× countersink)
•
aluminum mounting plate (see Page 64)
First, the mounting plate needs to be attached to the ProPak II enclosure. There are two channels running the length
of the bottom of the ProPak II enclosure. In each of these channels there are two rectangular nuts, held in place by
grub screws. These four nuts are factory-positioned so that the mounting plate can be attached to the ProPak II
enclosure using the four flat screws. Please ensure that the four flat screws are mounted from the countersunk side
of the mounting plate.
Once the plate has been attached to the ProPak II enclosure, the entire assembly can then be mounted onto a surface
using either the four self-drilling screws through the screw mount holes, or the two tapping screws through the
quick-mount holes.
WARNING:
The mounting kit is not designed for use in high-dynamics or high-vibration environments.
Contact your dealer or NovAtel Customer Service if your application requires the ProPak II
enclosure to be mounted in these types of environment.
GPS/GLONASS Receiver User Manual Rev 1
1
/
" LG)
2
3
/
" LG)
4
E ProPak II Enclosure
63
Advertisement
Table of Contents
