Table of Contents
Advertisement
E
PROPAK II ENCLOSURE
E ProPak II Enclosure
E.1 INTRODUCTION
The ProPak II enclosure, see Figure E.1, is rugged, reliable, and designed for adverse environments. It offers you
unparalleled flexibility. It is intended to be used with the following NovAtel accessories and options:
•
A NovAtel Model 504 or Model 514 L1 GPS/GLONASS antenna - single frequency
•
Model C005, C015, or C030 (5, 15 or 30 m lengths) coaxial cable - to connect the GPS/
GLONASS antenna to the ProPak II enclosure
•
33.5 cm or 75 cm 4-pin LEMO plug to 4-pin LEMO plug connector (NovAtel part numbers
01016724 and 01016725 respectively)
•
Model GPS-APRO auto-ranging AC/DC converter and power cables.
After the addition of these accessories together with user-supplied data communications equipment and a power
supply, the ProPak II enclosure will be ready for the most demanding applications.
E.1.1 FEATURES
The ProPak II enclosure comes with the following:
•
rugged, shock, water, EMC, EMI and dust-resistant enclosure
•
two serial communication ports
•
an I/O strobe port
•
one RF port
•
an input power port
•
a mounting plate
•
one straight and one null-modem serial data cable
•
one I/O strobe cable
•
one 4-pin LEMO socket connector to cigarette lighter plug with built-in 3 amp slow-blow
fuse
The enclosure measures 251 mm x 130 mm x 62 mm, weighs 1.3 kg and is constructed of extruded aluminum. The
enclosure is sealed by two end-caps, and the entire unit is closed with five mounting screws.
NOTE:
The unit is sealed to provide protection against adverse environmental conditions; therefore, any
attempt to open the case will impair the water-resistant qualities of the enclosure, and void the warranty.
GPS/GLONASS Receiver User Manual Rev 1
Figure E.1 ProPak II Enclosure
E ProPak II Enclosure
59
Advertisement
Table of Contents
