Furuno FS-1575 Service Manual page 572

70. INACTIVITY TIMER! Closing sequence! count down 30s.
DISTRESS RX DISTRESS ACK FROM xxxxxxxxx <Agree / Pause>
A discrete alarm sound goes off. It goes off when a given period of time elapses
without performing any operation after the procedure is initiated and the remaining
procedure survival time comes to 30 seconds. The RT procedure is an exception
and automatically completed without indication.
The condition for deleting this message is that the cursor is put on "Agree" of User
options to press the [ENTER] knob or a period of 30 seconds elapses after the
popup message appears.
71. Change COM FREQ! Count down XXs. <Agree / Disagree>
This message goes off when any Distress alert or Distress alert acknowledgement
message other than messages that "make a change to communication frequency
without waiting for User Option setting is received.
The condition for deleting the message is that User Option is set to any menu, and
then the [ENTER] knob is pressed, or the countdown display reaches "0" second.
72. Are you sure to send ALL ACK? ALL ACK normally done by coast station.
<Yes / No>
This message goes off when ACK TYPE setting is changed to "ALL" on the
window used to create acknowledgement for Relay Individual message. The
condition for deleting the message is that the [CANCEL] key is pressed or User
Option is set to any menu, and then the [ENTER] knob is pressed.
73. Are you sure to disconnect NBDP? <Yes / No>
This message goes off when performing operation that puts the NBDP
communication procedure into a hold state or a quit state, or performing operation
that puts other procedure into an active state, or trying to switch to the MENU
window, while NBDP communication is in progress.
The condition for deleting the message is that the [CANCEL] key is pressed or
User Option is set to any menu, and then the [ENTER] knob is pressed.
74. Are you sure to quit one session? <Yes / No>
This message goes off when performing operation that boots the new RT procedure
at the maximum size of the procedure tab.
The condition for deleting the message is that the [CANCEL] key is pressed or
User Option is set to any menu, and then the [ENTER] knob is pressed.
75. Are you sure to disconnect PSTN?
This message goes off when the [CANCEL] key is pressed during a PSTN call or
the User Option "END CALL" key is pressed. The condition for deleting the
message is that the [CANCEL] key is pressed or User Option is set to any menu,
and then the [ENTER] knob is pressed.
CONFIDENTIAL (internal use only)
This confidential document is used only by FURUNO authorized persons.
It is strictly prohibited to reproduce the document in whole or in part without prior written permission of FURUNO.
<Yes / No>
AP2-10
Appendix 2. Message List