Q68. I Would Like To Know The Procedure For Making Dsc Test Calls; Q69. I Would Like To Know The Procedure For Conducting Test Calls With Nbdp - Furuno FS-1575 Service Manual

Ssb radiotelephone
Hide thumbs Also See for FS-1575:
Table of Contents

Advertisement

Q68. I would like to know the procedure for making DSC test calls.

A68. Since DSC test calls are categorized into the Safety call, Distress and Safety
frequencies is used. Voice calls after DSC test call is not allowed.
Japan Tokyo Sea Patrol Radio: 004310001
Shanghai, China: 004122100
Chilung, Taiwan: 004162019
Hong Kong: 004773500
Procedure)
1. Click on the [OTHER DSC MSG] key.
2. Set "MSG TYPE" to "TEST MSG."
3. Enter the MMSI of the other party of calling in the "TO" column.
4. Set "DSC FREQ" to Distress and Safety frequency ranging from 2 to 16 MHz
in consideration of calling distance.
5. Put the cursor on "GO TO CALL," and then press the [ENTER] knob.
Transmission will be initiated.
6. Upon completion of transmission, the display will switch to the "WAIT FOR
ACK" window to wait for a response from the other party.
7. When receiving a response from the other party, a message saying "TEST
ACK received!" will appear on the window. Then, review the response
received and complete the test call.
8. If no response from the counter party is received even after a lapse of five
minutes or more from the transmission, select a different frequency to make a
test call again.
Reference)
For test calls, it is recommended to monitor the ACK reception signal referring
to information on page 4-41. You can check communication state.
If no response from the other party, check for TX output power and frequency,
and change the frequency or Radio station.

Q69. I would like to know the procedure for conducting Test calls with NBDP.

A69. You communicate with a radio station handling public communications. When
you receive a response from the Coast radio station, you enter an automatic
response command such as "TEST+" or "HELP+" to receive a routine message.
Of course, you can call an operator with the "OPR+" command to communicate
with the operator. In this case, you should ensure the AAIC, CS, and Ship's name
beforehand because you will be asked by the operator for the registration with the
Coast radio station.
CONFIDENTIAL (internal use only)
This confidential document is used only by FURUNO authorized persons.
It is strictly prohibited to reproduce the document in whole or in part without prior written permission of FURUNO.
Guangzhou, China: 004123100
Charleville/Wiluna, Australia: 005030001
Lyngby, Denmark: 002191000
9-12
Chapter 9 Q&A
See OM
See OM

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fs-2575Fs-5075

Table of Contents