Ap2.4 Status Messages - Furuno FS-1575 Service Manual

AP2.4 Status Messages

54. TUNING
This message goes off when the [0/TUNE] key is pressed and held for a period of
one second or more and the ATU is in the process of tuning.
55. TUNE OK
This message goes off when the ATU is put into a Tuning OK status. It is deleted
after a lapse of a given period of time.
56. Tx
This message goes off when the PTT key is pressed.
57. System was rebooted.
This message goes off when the watchdog timer for any of the SH-2A, DSP, Nios2,
and 78K CPU of T-CPU used in the FS-xx75T gets activated to reboot the system.
It is deleted after a lapse of a given period of time.
58. NBDP connecting [CANCEL]: Close window
This message goes off when the system initiates NBDP connection processing. The
condition for deleting the message is that the [CANCEL] key is pressed or the
system completes NBDP connection processing.
59. NBDP disconnecting [CANCEL]: Close window
This message goes off when the system initiates NBDP disconnection processing.
The condition for deleting the message is that the [CANCEL] key is pressed or the
system completes NBDP disconnection processing.
60. CH BUSY! [CANCEL]: Tx cancel
This message goes off when any DSC message other than a Distress alert cannot be
outputted because the transmission frequency is in use. The condition for deleting
the message is that the [CANCEL] key is pressed. To retransmit this message,
cancel the transmission of the message once, and then transmit it.
61. Tx power reduced. Continuous operation over one minute on FEC Mode.
[CANCEL]: Close window
This message goes off when NBDP communication continues for a period of one
minute or more in FEC mode with Tx power set to "High." The condition for
deleting the message is that the [CANCEL] key is pressed or the system exits from
FEC mode. At this time, transmission output power automatically reduces. With
the FS-5075 system, it reduces to the LOW 2 level.
62. PSTN connecting [CANCEL]: Close window
This message goes off when the system received a PSTN message and is
conducting signal strength level tests. The condition for deleting the message is
that the [CANCEL] key is pressed or the system receives signal strength test
acknowledgement from the coast radio station.
CONFIDENTIAL (internal use only)
This confidential document is used only by FURUNO authorized persons.
It is strictly prohibited to reproduce the document in whole or in part without prior written permission of FURUNO.
AP2-8
Appendix 2. Message List