T-If Board: 05P0861, 05P0861A (Fs-5075/-2575, -1575); C-Cpu Board: 05P0852 - Furuno FS-1575 Service Manual

13. T-IF board: 05P0861, 05P0861A (FS-5075/-2575, -1575)

Ensure the J8 jumper setting.
This setting is made to select "N.C." (2-3: Normally Closed) or "N.O." (1-2: Normally
Open) for ALM output (contact output).

14. C-CPU board: 05P0852

When a combination of programs installed to the T-CPU board is different from that of
programs installed to the C-CPU board of the FS-2575C unit, programs will be
automatically loaded from the T-CPU into the C-CPU.
1) Ensure setting items saved in the C-CPU.
For setting items, refer to information on page 6-47.
2) Set the "S2" DIP switch all to "OFF."
CONFIDENTIAL (internal use only)
This confidential document is used only by FURUNO authorized persons.
It is strictly prohibited to reproduce the document in whole or in part without prior written permission of FURUNO.
DIP SW: S2
(ALL OFF)
6-72
6.10 Replacement of Boards
J8