Panel Board: 05P0844; C-If Board: 05P0853; Fet Board: 05P0872; P-Sw Board: 05P0871 - Furuno FS-1575 Service Manual

6.10 Replacement of Boards

15. PANEL board: 05P0844

No setting is required.

16. C-IF board: 05P0853

No setting is required.

17. FET board: 05P0872

No setting is required.

18. P-SW board: 05P0871

No setting is required.

19. PWR board: 05P0874

No setting is required.

20. SW REG board: 05P0873

No setting is required.

21. COUP board: 05P0875 (AT-5075), 05P0883 (AT-1575)

• AT-5075: Ensure the settings of the J10 (RX GND) and J11 (ANT BK) jumpers.
• AT-1575: Ensure the settings of the J5 (RX GND) and J4 (ANT BK) jumpers.
When connecting the COUP board to FS-1575, -2575, or -5075, no jumpers above are
used. Mount a jumper pin between J10 (or J5) and J11 (or J4).
For details, refer to information on page 4-93.
AT-5075
AT-1575
6-73
CONFIDENTIAL (internal use only)
This confidential document is used only by FURUNO authorized persons.
It is strictly prohibited to reproduce the document in whole or in part without prior written permission of FURUNO.